Table of Contents
Advertisement
Wall Installation (applicable for both zone controller or remote sensor)
Run a green RJ45 cable through a 25mm diameter hole in the wall.
Plug in RJ45 Cable and secure the controller in the control bracket.
1
To 12V DC power source
Wall mates (x2)
Plyboard wall
NOTE:
• Use screws provided.
• Use provided wall plug (x2) in leu of wall mates if applicable.
• Wall mates or wall plug must be totally flush to the wall.
• Hole for cable MUST NOT be MORE THAN 25 mm in diameter
• Caution should be taken to ensure that there is adequate hole clearance and wall
cavity depth to avoid unnecessary pressure to the cable and its connection point.
10
Zone controller /
remote sensor
Screws (x2)
Mounting bracket
2
Hide quick links:
Advertisement
Table of Contents
