(ii)
On the right side of the remote sensor, press and hold the
pair button for three seconds.
•
Green blinking light means pairing is successful.
•
Red blinking light means pairing has failed.
Repeat this step until pairing is successful.
(iv) The next screen will show that the Remote Sensor is now
paired to the zone. It will also show the serial number of
the connected device. Make sure this is the same serial
number of the actual connected device (check the back of
the device for serial number).
Touch 'Back'.
(v)
Zone summary will also show remote sensor is paired
to the zone.
Pair button
(press here)
19