8
The next process will begin the setup of your system and/or
connecting zone devices. Touch
required in the system, otherwise touch
NOTE:
Touching
will use the default configuration. As a default, sensor
assigned is from master wall controller. Proceed to (4) Account Setup.
Setting up a Non-Zoned System
a
After step 8 above, touch 'Please setup system devices'.
Select which device will be used on the system.
b
(i) Touch to use a remote sensor. Then follow the on screen
instructions to setup.
OR
(ii) Touch to use master controller. Then follow the on screen
instructions. It is possible to use the secondary controller if
connected. This will be visible on screen.
NOTE:
Zone controller is not allowed in non-zoned system.
system or zone set up is
.
15