Mill The Calibration Body; Start The Kavo Everest Base Camp Control; Change The Milling Tool - KaVo Everest engine Base Camp 4140 Assembly Instructions Manual

Assembly instructions Everest
7 Calibrate the Everest engine Base Camp 4140
engine Base Camp 4140
®

7.2 Mill the calibration body

7.2.1 Start the KaVo Everest Base Camp control

▶ Double-click to start the KaVo Everest Base Camp control.
▶ Press the function key Start on the control panel to do a reference run.

7.2.2 Change the milling tool

Note
The milling tools can be used for a max. 10 calibrations.
▶ In the program Everest Base Camp Control in the menu Machine, select the
submenu Tool change. Key combination [Alt] + [W]).
▶ Function keyStart on the control panel.
The double spindle runs in the centre and remains in a horizontal position so that
the tool can be changed.
An appropriate message appears on the monitor.
▶ At position T1 = clamp the titanium Ti, dia. 3 mm.
▶ At position T2 = clamp the titanium Ti, dia. 1 mm.
|
7.2 Mill the calibration body
28/51