Table of Contents
Advertisement
Assembly instructions Everest
7 Calibrate the Everest engine Base Camp 4140
engine Base Camp 4140
®
▶ Undo the stud bolt ① at the tool mounting using the torque wrench (2.5 mm)
④, but without fully removing it.
▶ Insert tool ② into the tool holder so that the clamping surface ③ faces forward,
and insert it until it stops.
▶ Gently press the tool ② into the tool mounting and screw in the stud bolt ① at
the same time.
The tool is in the correct position if, after gently tightening the screw, it can only be
moved within the two inside recess grooves.
▶ Tighten the stud bolt ① using the torque wrench ④ until an acoustic signal
sounds.
▶ Close the door of the milling/grinding unit.
▶ Function keyStart on the control panel.
The double spindle moves to its basic position and misses the tool.
|
7.2 Mill the calibration body
29/51
Advertisement
Table of Contents
