Connector - Panasonic WJ-HD309A Operating Instructions Manual

I How to Use the Terminals of the ALARM Connector
These terminals are used to connect the alarm devices, such as sensors, door switches, etc.
The pin configurations of these terminals are as shown below. The connector used should be compatible with the pin configu-
ration.
Pin Configuration
The pin array is different from other disk recorders. Make sure that the connection is correct by referring to the following.
Pin No.
q
Ch 1 alarm input
w Ch 2 alarm input
e
Ch 3 alarm input
r Ch 4 alarm input
t
Ch 5 alarm input
y
Ch 6 alarm input
u Ch 7 alarm input
i
Ch 8 alarm input
o Ch 1 alarm output
!0
Ch 2 alarm output
!1
Ch 3 alarm output
!2
Ch 4 alarm output
!3 , !4
Earth (Grounding)
!5 Ch 9 alarm input
!6
Ch 10 alarm input
!7
Ch 11 alarm input
!8
Ch 12 alarm input
!9
Ch 13 alarm input
@0 Ch 14 alarm input
@1
Ch 15 alarm input
@2
Ch 16 alarm input
@3
Ch 5 alarm output
@4
Ch 6 alarm output
@5 Ch 7 alarm output
90
!3
@5
Signal
Event action will be performed according
to the settings.
Alarm signal will be supplied at an event
occurrence
Event action will be performed according
to the setting.
Only for the WJ-HD316A
(Not available for the WJ-HD309A)
Alarm signal will be supplied at an event
occurrence
q
ALARM
!4
Operation Remarks
Non-voltage make contact/–100 mA,
5 V pull-up
Open collector output/24 V, 100 mA
Non-voltage make contact input/
–100 mA, 5 V pull-up
Open collector output/24 V max.,
100 mA