Panasonic WJ-HD309A Operating Instructions Manual page 116

Note:
• Depending on the set positions of the motion detection
areas, the sensitivity indications of the detection areas
may be displayed overlapping each other.
• Depending on the set position of the detection area, a
part of the sensitivity indication of the detection area
may not be displayed.
[Screenshot 2]
The sensitivity of the selected detection area will be dis-
played.
x Move the cross cursor to select an area using the
arrows button (C D A B).
c Select the sensitivity for the selected area by rotating
the jog dial from the following.
OFF: No motion will be detected in this area.
LOW: Low sensitivity
MID: Standard sensitivity
HIGH: High sensitivity
Note: When a motion is detected with the selected sen-
sitivity, the motion detection area where the motion
was detected will turn red and the buzzer will start
sounding.
v Set the sensitivity for all the detection areas by repeat-
ing steps 2 and 3.
b To complete the settings, rotate the jog dial to select
"EXIT" on the status bar, and press the SET button.
→ The "VMD Setup" window will be closed.
8 Set the detection mode
Perform the settings of the detection mode (method of
detection) in the set detection area. Specifying a method of
detection in a detection area is available by setting the
detection mode.
116
[Screenshot 1]
Start operation from the "VMD Setup" window.
z Press the SET button after selecting "VMD MODE" by
rotating the jog dial.
[Screenshot 2]
The detection mode menu will be displayed.
x Set the detection mode.
Move the cursor to the desired detection mode using
the arrows button (C D A B).
Move the cursor on the desired detection mode using
the arrows button (A B) and check the radio button
next to the selected mode using the jog dial.
Refer to the following for further information about each
of the detection modes.
<ANY AREA>
An event action will be performed according to the set-
tings when "motion" is detected in any of the set motion
detection areas.
<VECTOR>
Move the cursor to an area for the settings of VECTOR
using the arrows button (C D A B) and select an area
using jog dial. Move the cursor to the parameter box of
the selected area using the arrows button (A B), and
then rotate the jog dial to select an interval time for an
object moving between each area from the following.
--/5 s/10 s/20 s/30 s/40 s/50 s/1 min
<DURATION>
Move the cursor to the parameter box of each area
using the arrows button (C D A B) and select a mov-
ing duration for an object in each area from the follow-
ing using the jog dial.
0 s/5 s/10 s/20 s/30 s/40 s/50 s/1 min
c After completing the settings, press the SETUP/ESC
button.