Connecting An External Device Via The Usb Host Connector - Panasonic AG-HPD24P Operating Instructions Manual

Memory card portable recorder
Hide thumbs Also See for AG-HPD24P:
Table of Contents

Advertisement

FORMAT ERROR!:
NOT SUPPORTED!:
NO CARD!:
3)
P2 card remaining memory (or memory used)/total
memory
Indicates P2 card remaining free memory (or memory
used)/total memory in time left in minutes. Fractions of
a minute are rounded off on the display so that the sum
total of the remaining memory available for recording
on each P2 card may not tally with the figure for the
total memory.
4)
Slot remaining memory (or memory used) total
The figure obtained by totaling the remaining free
memory (or memory used) on the two P2 slots is shown
here.
◆ NOTE:
• Free space of write-protected P2 cards is not included in
the free space total.
5)
Detailed P2 card status
Select the slot of the P2 card whose status you want to
check and press the SET button to view the P2 card
model number and other detailed information.
Press the SET or EXIT button again to close the
detailed information dialog.
6)
Card warning messages
This warning appears when the following P2 cards are
inserted.
Open Detailed P2 Card Status for more information on
this warning.
• "RUN DOWN CARD"
The maximum number of overwrites has been
exceeded.
• "DIR ENTRY NG"
The P2 card directory structure is not supported.
4
Press the EXIT button to end processing.
◆ NOTE:
• If the number of clips recorded on a P2 card exceeds the limit,
"OVER MAX NUMBER CLIPS" appears in the detailed P2 card
status indicating that the limit has been exceeded.
An unformatted P2 card is
inserted.
This unit does not support the
inserted card.
No P2 card has been inserted.
Connecting an External Device via the
USB HOST Connector
Usable storage devices
The following storage devices can be used.
• Panasonic portable hard disk unit P2 store (AJ-PCS060G)
• Hard disk drives or solid state drives connected via USB
2.0/3.0.
◆ NOTE:
• The unit supports P2 store only in version Ver2.** or later version. P2
store hard disk in Ver1.** cannot be connected. Upgrade a hard
disk using Ver1.** to the latest version before use.
Main Mode: Thumbnail Screen
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ag-hpd24eAg-hdp24pAg-hdp24e

Table of Contents