Panasonic WJ-HD309A Operating Instructions Manual page 38

MONITOR1
MONITOR2
R
1 2 3
R
SHIFT SEQ OSD
5 6 7
DISK SELECT COPY TEXT MARK
9 10/0
11
1
EL-ZOOM LOGOUT LOGOUT
2 13 14 15
m
Move the cross cursor using the arrows button
to a point to be determined as the end point of
the motion detection area.
Press the SET button to determine the selected point as the
end point of the motion detection area.
It is possible to set up to 4 motion detection areas by
repeating steps 6 and 7.
,
Press the SET button after selecting "SENSI-
TIVITY" by rotating the jog dial.
Notes:
• Depending on the set positions of the detection areas,
the sensitivity indications of the detection areas may be
displayed overlapping each other.
• Depending on the set position of the detection area, a
part of the sensitivity indication of the detection area
may not be displayed.
38
⁄1
STOP PLAY PAUSE REC - REC STOP
REV
4
PAN/ GOTO
TILT LAST SEARCH
SETUP
PAN/TILT
8
SLOW /ESC
ZOOM/
A-B
FOCUS REPEAT
–
12 IRIS
LISTED
PRESET
/AUTO
16
SET
BUSY
m,⁄2 ,⁄0 ⁄ 2
m.
.
Move the cross cursor to the motion detection
area to apply the sensitivity using the arrows
button (D C A B).
FWD
+
316
⁄0
Select the sensitivity using the jog dial from
the following.
OFF: Motion will not be detected
LOW: Low sensitivity
MID: Standard sensitivity
HIGH: High sensitivity
Note: Depending on the set positions of each motion
detection area, the sensitivity parameters for the motion
detection areas may be displayed overlapped with
each other.
⁄1
After completing the sensitivity settings for the
detection areas by repeating steps 9 and 10,
press the SETUP/ESC button.
⁄2
Press the SET button after selecting "VMD
MODE" by rotating the jog dial.