Panasonic WJ-HD309A Operating Instructions Manual page 88

G Connection for the Auto Adjust Time function
• When "Auto Adjust Time" of "System" on the SETUP MENU is set to "MASTER"
"Time Adjust Output" becomes available and the clock of this unit can be applied to other units.
• When "Auto Adjust Time" of "System" on the SETUP MENU is set to "SLAVE"
"Time Adjust Input" becomes available. When a signal output from other equipment is supplied to the time adjust I/O terminals
between 00 minutes 00 seconds and 14 minutes 59 seconds every hour or between 45 minutes 00 seconds and 59 minutes
59 seconds every hour, the clock will be set to "00 minutes 00 seconds" of the closest hour.
Example:
Signal is supplied at 2:50:00 (hour:minute:second)pm → Set at 3:00:00 pm
Signal input supplied at 3:14:45 pm → Set at 3:00:00 pm
Signal is supplied at 3:20:00 pm → Time will not be adjusted.
Important:
• When "SLAVE" is selected, the auto time adjustment function works differently depending on the recording status as fol-
lows:
When no recording is being performed
When manual recording is being performed
When schedule recording is being performed
When event recording is being performed
When emergency recording is being performed
*1
: When event recording is performed on any camera channel
• Recording will not be performed for around 4 seconds when the clock is adjusted during recording.
88
(Earth)
(Time adjust output)
!3 @0
ALARM/CONTROL
(Earth)
(Time adjust input)
!3 @0
ALARM/CONTROL
*1
Terminal block of other units
Front LED
monitor
output
Terminal block of other units
Front LED
monitor
output
The clock will be adjusted when the clock becomes inaccu-
rate beyond ±5 seconds.
The clock will not be adjusted.