Panasonic WJ-HD309A Operating Instructions Manual page 40

G
To delete the motion detection area
MONITOR1
MONITOR2
R 1 2 3
R
SHIFT SEQ OSD
5 6 7
DISK SELECT COPY TEXT MARK
9 10/0
11
1
EL-ZOOM LOGOUT LOGOUT
13 14 15
2
z
Rotate the jog dial to select "DELETE AREA"
on the status bar.
Note: To delete all the motion detection areas, select
"DELETE ALL AREA" and press the SET button.
x
Move the cursor to the motion detection area
to be deleted using the arrows button and
press the SET button.
The selected area will be deleted.
G Detection Mode
Set how to detect motion in the set motion detection area.
There are 3 detection modes as follows.
Note: It is impossible to set two or more detection modes
simultaneously.
<ANY AREA mode>
It will be subject to listing if "motion" is detected in any of
the set motion detection areas.
A
C
40
STOP PLAY PAUSE REC - REC STOP
REV
4
PAN/ GOTO
TILT LAST SEARCH
SETUP
PAN/TILT
8 SLOW /ESC
ZOOM/
A-B
FOCUS
REPEAT
–
12 IRIS
LISTED
PRESET
/AUTO
16
SET
BUSY
x
zx
B
D
Any motion will be detected anywhere in the A, B, C, D
areas.
Note: In the ANY AREA mode, it is possible to set the
masking duration. When the masking duration is set,
FWD
motion will be ignored for a certain period (set duration
as the masking duration) in the same area. It is conve-
+
nient to set the masking duration to make the subject
period shorter in case it is necessary to search an
316
extended time range or when searching through many
results.
z
<VECTOR mode>
It will be subject to listing if an object moves within the set
time to the other detection areas in the set order.
The following is an example.
Motion is detected in area B within 10 seconds after being
detected in area A.
Motion is detected in area C within 20 seconds after being
detected in area B.
Motion is detected in area D within 10 seconds after being
detected in area C.
When all of the above have occurred, an event action will
be performed.
<DURATION mode>
It will be subject to listing if an object keeps moving for the
set period in the detection area. For example, in case of the
following settings; 10 sec. for areas A and B, 20 sec. for
area C and 30 sec. for area D:
An event action will be performed when an object keeps
moving longer than the set period in the specified detection
area.
Important:
• When images to be searched are recorded with a low
recording rate, the DURATION mode may not work cor-
rectly.
• It may take some time to search according to the con-
tents of the recorded images.
10 s
A B
C D
10 s
10 s 10 s
A B
C D
20 s 30 s