Table of Contents
Advertisement
2.
INSTALLATION
The 2430DAC-HD is a compact module that has two BNC connectors and one high density 15 pin D
connector for video, and a serial port for firmware upgrades.
2.1.
POWER
The 2430DAC-HD comes with an auto-ranging DC voltage adapter that automatically senses
the input voltage. Power should be applied by connecting a 3-wire grounding type power
supply cord to the power entry module on the DC voltage adapter. The power cord should be
minimum 18 AWG wire size; type SST marked VW-1, maximum 2.5 m in length. The DC cable
of the voltage adapter should be connected to the DC power jack on the rear panel. A green
LED located beside the power connector will be illuminated when there is power applied to the
2430DAC-HD.
2.2.
VIDEO IN AND OUT
HD INPUT:
Input BNC connector for 10-bit serial digital video signals, compatible with the
SMPTE 292M standard. The 2430DAC-HD automatically selects the video standard.
HD OUTPUT: This BNC connector is used to output a reclocked copy of the input video.
VIDEO OUTPUT:
connectors. The outputs can be programmed as standard VGA signals or Y, Pb, Pr or RGB
outputs from the 2430DAC.
superimposed. The output signals available are selected using DIP switches 1 to 4. (See
Table 5-2) When the VGA mode is selected you can connect a standard VGA monitor using a
straight through VGA Cable. When other modes are selected you can connect a standard
broadcast monitor using the 15 pin D to BNC adapter cable provided with the module (Evertz
part #WPVGABNC5
2430DAC-HD HDTV Digital to Analog Converter Manual
Figure 2-1: 2430DAC-HD Module
This female HD 15 pin D connector is compatible with standard VGA monitor
.
)
These outputs can have either bi-level or tri-level sync
Revision 1.2
2430DAC-HD - 1
Advertisement
Table of Contents
