Electrolux RKG500002W User Manual page 16

16 www.electrolux.com
6.1 Ignition of the hob burner
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you
use open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Push and hold the spark generator
button
2. At the same time turn the knob for
the hob counterclockwise to the
maximum gas flow position
push it down to light the burner.
3. Release the spark generator button
when burner lights but keep the knob
on this position for equal or less than
10 seconds to let the thermocouple
warm up. If not, the gas supply will
be interrupted.
4. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push
the relevant knob down and
turn it to maximum position.
Keep the knob pushed for
equal or less than 10
seconds to let the
thermocouple warm up.
.
If the burner accidentally
goes out, turn the knob to
the off position and try to
light the burner again after
minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
6.2 Burner overview
and
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple
6.3 Turning the burner off
To put the flame out, turn the knob to the
off position
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.
.
A
B
C
D