Table of Contents
Advertisement
2430RX-J2K-IP
JPEG2000 to HDMI Converter User Manual
VANC PID Select: This control allows the user to select the VANC PID which will be decoded. This
control is only applicable when the Program Tuning Mode is set to Manual PID Select. Range for
these values can be set from 2 to 8190.
Note: 0, 1 and 8191 are reserved PID's in MPEG, so these values are not
included.
PID Configuration: This parameter configures the method in which PIDs are set. It can be user
defined or pre-assigned, in which case all the PID controls will be greyed out.
Decoder Up Time: This controls returns a string representation of the time the decoder was last
restarted. It is represented similar to 'xxxx days yy hrs zz min aa sec'. Internally, it is a 31 bit unsigned
integer, reflecting seconds which will provide for up to 3100 days of operation before it wraps around.
6.3.
DECODER OUTPUT CONTROL
Output Video Color: This parameter allows the user to select the output video color that will be sent
when J2K input is missing and the output VideoMode is set to continuous. Options can be set to ether
Black, Green, Blue or Freeze.
SDI Audio Source: This parameter allows the user to enable or disable the audio service which will be
embedded into the audio group of the SDI/HDSDI output.
HDMI Audio Source: This parameter allows the user to enable or disable the audio service which will
be embedded into the audio group of the HDMI output.
Page - 22
Figure 6-3: Web GUI Decoder Output Control Tab
Revision 0.1
Advertisement
Table of Contents
