Decoder Output Control; Figure 5-2: Decoder Output Control Tab - evertz 2430RX-J2K-IP Series User Manual

Reboot: Part of the decoder Output table, this variable allows the SNMP Manager to perform a
remote reboot of the decoder. This is useful when the IP interface (and other) changes have been
made, and a reset is needed to make them take affect. The manager should read the variable prior to
resetting, to ensure it is in the 'ready' state. Writing the 'reboot' command will cause the decoder to
perform a software restart of the decoder. VLPro will communicate with the operator to confirm the
desire to reboot. If the decoder card is working with a companion card (IP-ASI), VLPro will also issue
a coordinated reset command to that card as well.
This is done by issuing the following: commandEntryEntry: commandIndex = adminCommand,
commandString = 'reset'.

Note: The decoder will react immediately to reboot command, and will not
respond to the SNMP set command.
5.2.

DECODER OUTPUT CONTROL

General
Output Video Color: This control allows the user to select the output video color that will sent on the
output when input ASI is missing and the Output Video Mode is set to continuous. The user can set
this to black, green, and freeze.

Figure 5-2: Decoder Output Control Tab

Revision 0.1
JPEG2000 to HDMI Converter User Manual
2430RX-J2K-IP
Page - 11