evertz 2430RX-J2K-IP Series User Manual page 32

2430RX-J2K-IP
JPEG2000 to HDMI Converter User Manual
Enable Video Proc: This control will Enable or Disable the video processor module.
Enable YCbCr Proc: This control will Enable or Disable the YCbCr processor block.
Y Gain: This control allows the user to adjust the gain for the Y component in the YCrCb domain.
Range for this value can be set from -100% to 100%.
Y Offset: This control allows the user to adjust the DC offset of the Y component in =/- 200
quantization increments.
Saturation Gain: This control allows the user to set the saturation gain from -100% to 100%.
Hue: This control allows the user to adjust the hue. Range for this value can be set from -180º to 180º.
Luma Gamma Enable: This control allows the user to Enable or Disable the luma gamma.
Luma Gamma Value: This control allows the user to adjust the gamma correction factor. Range for
this value can be set from -100 to 100.
Enable RGB Proc: This control allows the user to Enable or Disable bypasses on the RGB processor
block.
Video Gain: This control allows the user to adjust the gain of the RGB component in the RGB Domain.
Range for this value can be set from -100% to 100%.
Gamma R/G/B: This control allows the user to adjust the gamma correction factor for the Red, Green,
and Blue gamma levels. Range for this value can be set from -100 to 100.
Minimum R/G/B: This control allows the user to adjust the Red, Green, and Blue minimum levels.
Range for this value can be set from -100 to 100.
Maximum R/G/B: This control allows the user to adjust the Red, Green, and Blue maximum levels.
Range for this value can be set from -100 to 100.
Low Knee Size: This control allows the user to set the lowest knee size. Range for this value can be
set from 0 to 31.
High Knee Size: This control allows the user to set the lowest knee size. Range for this value can be
set from 0 to 31.
Video Processor Reset: This control resets the video processor.
Page - 24
Revision 0.1