Demand Window; Kyz Setup (Iq 320 And Iq 330 Base Module Only); Digital Output Setup (Iq 330 & Iq 330M Base Module Only) - Eaton Cutler-Hammer IQ 300 Series Instructions For Installation, Operation And Maintenance

IL17574C
Page 4-16
4.9.8

Demand Window

Scroll up or down until WINDOW MIN is displayed.
This screen, shown in figure 4.19, indicates the time over
which demand parameters are measured. If the time
displayed is not correct, proceed to section 4.10 Edit Set
Points for additional information.
4.9.9 KYZ Setup (IQ 320 and IQ 330 Base
Module only)
Scroll up or down until KYZP <XXXX> or KYZ RATE is displayed. The <XXXX> will
be replaced with NONE, VAh, -VARh, +VARh, -Wh or +Wh, this represents the
system value being monitored.
The KYZP <XXXX> screen, shown in figure 4.20, indicates the system value which
the IQ 320 and the IQ 330 will monitor, or Track. The KYZ rate screen, shown in
figure 4.21, indicates the energy per pulse Rate over which energy demand
(consumption) is measured. If the values displayed are not correct, proceed to
section 4.10 Edit Set Points for additional information.
KYZP NONE
Figure 4.20 KYZ
Value
4.9.10 Digital Output Setup (IQ 330 & IQ 330M Base Module Only)
Scroll up or down until O A1: <XXXX> or O A2: <XXXX> is displayed. The <XXXX>
will be replaced with PHASE, MSG, VOLT or NULL, depending on your selection.
These screens, shown in figure 4.22 and 4.23, indicates the status of the two "form
A" output relays. Each of the two relays can be programmed to respond to MES-
SAGE, VOLTAGE or PHASE. When NULL is displayed the output is disabled.
When in MESSAGE mode the relay will be open or closed depending on an
external message received by the unit.
O A1 PHASE
Figure 4.22 Digital
Output A1
Page 4-16
For more information visit:
Effective Date: 2/04
1
IQ 300
X
KYZ RATE
Figure 4.21 KYZ
Rate Display
O A2 PHASE
Figure 4.23 Digital
Output A2
www.cutler-hammer.eaton.com
X
Demand
WINDOW MIN
Figure 4.19 Demand
Window
1
Effective Date: 2/04