Table of Contents
Advertisement
2.
INSTALLATION
The SRF splitters and combiners have RF coaxial connectors on the front and back side of the chassis.
The common and monitoring ports are on the front of the panel. Output connectors are located on the
rear side of the chassis.
The monitoring port can be used for diagnostics and monitoring. This port is a –20dB tap of the common
port. Terminate this port with a 75 Ohm load when not connected.
Please note all unused ports on a channel (including monitoring ports) must be
terminated with a 75 Ohm load if they are not connected. Please contact Evertz
Microsystems for recommended termination suppliers.
SRF Series Splitters and Combiners
Revision 0.3
Page-5
Advertisement
Table of Contents
