Declarations Of Conformity; Antennas - Digi XBee SX 868 User Manual

Regulatory information
UK Conformity Assessed (UKCA) labeling requirements
See guidance/using-the-ukca-marking
You must make sure that:
if you reduce or enlarge the size of your marking, the letters forming the UKCA marking must
n
be in proportion to the version set out below
the UKCA marking is at least 5 mm in height – unless a different minimum dimension is
n
specified in the relevant legislation
the UKCA marking is easily visible, legible (from 1 January 2023 it must be permanently
n
attached)
the UKCA marking can take different forms (for example, the colour does not have to be solid),
n
as long as it remains visible, legible and maintains the required proportions.
Important note
Digi customers assume full responsibility for learning and meeting the required guidelines for each
country in their distribution market. Refer to the radio regulatory agency in the desired countries of
operation for more information.

Declarations of conformity

Digi has issued Declarations of Conformity for the XBee RF Modules concerning emissions, EMC, and
safety. For more information, see www.digi.com/resources/certifications.

Antennas

The following antennas have been tested and approved for use with the XBee SX 868 RF Module:
Dipole (2.1 dBi), Digi PN A08-HABUF-P5I*
All antenna part numbers followed by an asterisk (*) are not available from Digi. Consult with an
antenna manufacturer for an equivalent option.
XBee® SX 868 RF Module User Guide
for further details.
Antennas
204