To (Transmit Options); Ni (Node Identifier) - Digi XBee SX 868 User Manual

AT commands
Set or display the lower 32 bits of the 64-bit destination address. When you combine DH with DL, it
defines the destination address that the device uses for transmissions in Transparent mode.
Parameter range
0 - 0xFFFFFFFF
Default
0x0000FFFF

TO (Transmit Options)

This command applies to the XBee SX 868 RF Module.
The bitfield that configures the transmit options for Transparent mode.
The device's transmit options. The device uses these options for all transmissions. You can override
these options using the TxOptions field in the API TxRequest frames.
Parameter range
0 - 0xFF
Bit Meaning
6,7 Delivery method
5 Reserved
4 Reserved
3 Trace Route
2 NACK
1 Disable RD
0 Disable ACK
When you set BR to 0 the TO option has the DigiMesh and Repeater mode disabled automatically.
Default
0x40 When BR = 0
0xC0 When BR = 1

NI (Node Identifier)

This command applies to the XBee SX 868 RF Module.
Stores the node identifier string for a device, which is a user-defined name or description of the
device. This can be up to 20 ASCII characters.
The command automatically ends when the maximum bytes for the string have been entered.
n
To set NIto its default value of one ASCII space, type ATNIfollowed by a space and press Enter.
n
XBee® SX 868 RF Module User Guide
Description
b'00 = <invalid option>
b'01 = Point-multipoint
b'10 = Repeater mode—directed broadcast of packets
b'11 = DigiMesh—not available when BR = 0
<set this bit to 0>
<set this bit to 0>
Enable a Trace Route on all DigiMesh API packets
Enable a NACK messages on all DigiMesh API packets
Disable Route Discovery on all DigiMesh unicasts
Disable acknowledgments on all unicasts
Addressing commands
123