Route The Cables - Raven VSN Installation Manual

CHAPTER 3

ROUTE THE CABLES

1. Route the VSN® connector on the Steiger/T9 VSN cable (P/N 115-2020-051) cable from the rear of the machine
under the cab on the right hand side and follow lines under the hood to the front right side.
FIGURE 9. Cable and Lines Routing
2. Plug the VSN® connector into the VSN unit from below.
FIGURE 10. VSN® Unit Connection
3. Route the cable through the cutout on the plastic trim.
14 VSN® Installation Manual for Case AFS Connect Steiger and New Holland PLM T9 (MY 2021 and Newer)