CHAPTER 3
CABLING
1. Using the power adapter provided, connect to the provided cabling for the display.
2. Plug the cabling into an open 12 V power connection.
3. Plug in the display.
4. Use the CAM 1 connection and the DMAC-OWM cable (P/N 115-2020-041) to adapt the 8-pin video adapter
cable (P/N 115-0172-608).
5. Connect the analog video feed from the VSN®.
NOTE:
The trigger wires and other camera inputs will not be used.
If desired, more cameras may be purchased and plugged into the other camera inputs on this display.
SYSTEM DIAGRAM
The system diagram for the VSN® analog video system can be found on the next page.
18 VSN® Installation Manual for Case AFS Connect Steiger and New Holland PLM T9 (MY 2021 and Newer)