Raven VSN Installation Manual page 15

FIGURE 5. Sturdy Mounting Diagram
FIGURE 6. VSN® Necessary Bracket Dimensions (mm)
The below hardware is included in the kit.
Bolts. M8-1.25 with 13mm of thread engagement into VSN torque to 20 ft-lb (27.1 N-m)
Lock Washers. M8
Flat Washers. M8
Rubber Isolators. 75 Durometer
Debris Shield (required). (P/N 107-0172-642)
Hardware must meet ≥750 hours salt fog rating, cannot be stainless steel or Zinc coated and should have an
aluminum rich coating.
NOTE: The left/right offset is not important for bracket design since it will be calibrated out. Ideally, the VSN
should be mounted on the right of the tractor hood.
Installation: VSN® Specifications
203.20
4 x 9.00 THRU ALL
152.40
Cutout for Connector
and LED Lens
179.20
INSTALLATION
11