Table of Contents
Advertisement
Maintenance
driving at recommended speed and
for recommended hours, visit a pro-
fessional workshop and have them
check the PPF system. Constant
driving with the PPF warning light
on can damage the PPF system and
undermine fuel economy.
Procedure for entering forced
engine activation mode
If the engine needs to be kept run-
ning whilst the vehicle is stopped to
inspect emission gas or perform
vehicle maintenance, follow below
procedure to enter forced engine
activation mode.
1. Place the shift dial in P (Park)
position with the vehicle stopped.
Engage the parking brake. Then,
follow the steps (1) to (5).
Below steps from (1) to (5) must
be completed within 60 seconds.
If not, the process is reset and
you must start again from step
(1).
1)Turn the ignition switch to the
ON position. Vehicles equipped
with the smart key, press the
ENGINE START/STOP button
twice without depressing the
brake pedal.
2)Place the shift dial in P (Park)
position and depress the accel-
erator pedal twice.
3)Place the shift dial in N (Neu-
tral) position and depress the
accelerator pedal twice.
8
108
4)Place the shift dial in P (Park)
position and depress the accel-
erator pedal twice.
5)With the brake pedal
depressed, start the engine,
and maintain idling state. The
engine remains in idle state and
the forced engine activation
mode is maintained even when
the gear is shifted to a differ-
ent position.
2. (
) indicator on the instrument
cluster blinks when the vehicle is
in forced engine activation mode.
Check the (
to ensure that the forced engine
activation mode is correctly
entered.
The (
) indicator continues
blinking until the forced engine
activation mode is cancelled.
When the mode is cancelled the
(
) indicator will stop blinking.
3. To cancel the forced engine acti-
vation mode, turn the vehicle off.
Emission control system
) indicator blinking
Advertisement
Chapters
Table of Contents
