Kia Sorento 2022 Manual page 124

Safety features of your vehicle
To install a Child Restraint System
on the rear seats, do the following:
1. Place the Child Restraint System
on a rear seat and route the lap/
shoulder belt around or through
the Child Restraint System, fol-
lowing the Child Restraint Sys-
tem manufacturer's instructions.
Make sure the seat belt webbing
is not twisted.
2. Fasten the lap/shoulder belt latch
into the buckle. Listen for the dis-
tinct "click" sound. Position the
release button so that it is easy to
access in case of an emergency.
ODEEV058042NR
3. Remove as much slack from the
belt as possible by pushing down
on the Child Restraint System
whilst feeding the shoulder belt
back into the retractor.
4 44
ISOFIX anchorage and top-tether anchorage
(ISOFIX anchorage system) for children
4. Push and pull on the Child
Restraint System to confirm that
the seat belt is holding it firmly in
place.
ODEEV058043NR
If your Child Restraint System man-
ufacturer recommends the use of a
top-tether with the lap/shoulder
belt, see Securing a Child Restraint
System seat with Top-tether
Anchorage system section in this
chapter.
To remove the Child Restraint Sys-
tem, press the release button on
the buckle and then pull the lap/
shoulder belt out of the Child
Restraint System and allow the seat
belt to retract fully.