Table of Contents
Advertisement
What to do in an emergency
OMQ4060034L
6. Loosen the wheel lug nuts coun-
terclockwise one turn each, but do
not remove any nut until the tyre
has been raised off the ground.
OMQ4061036L
OMQ4061035L
7. Place the jack at the front(1) or
rear(2) jacking position closest to
7
20
If you have a flat tyre (with spare tyre)
the tyre you are changing. Place
the jack at the designated loca-
tions under the frame. The jack-
ing positions are plates welded to
the frame with two tabs and a
raised dot to index with the jack.
WARNING
Jack location
To reduce the possibility of injury,
be sure to use only the jack provided
with the vehicle and in the correct
jack position; never use any other
part of the vehicle for jack support.
8. Insert the wheel lug nut wrench
into the jack and turn it clockwise,
raising the vehicle until the tyre
just clears the ground. This mea-
surement is approximately 30
mm (1.2 in). Before removing the
wheel lug nuts, make sure the
vehicle is stable and that there is
no chance for movement or slip-
page.
OMQ4PH061014L
9. Loosen the wheel nuts and
remove them with your fingers.
Slide the wheel off the studs and
Advertisement
Chapters
Table of Contents
