S&C IntelliRupter PulseCloser Manual page 136

Loop Restoration
136 S&C Instruction Sheet 766-530
The following indicators show Loop Restoration mode is in the Ready state:
• The Operation screen shows the Ready state in the Loop Restoration state indica-
tor. See Figure 80.
• The control module STATUS indicator blinks three times every 30 seconds to indicate
the Ready state is active. See Figures 81 and 82 on page 137.
• The Loop Restoration Ready DNP Status Point is set when the Ready state is active.
See Figure 80.
Figure 80. The Operation screen displays the Ready state in the Loop Restoration status
indicator.