Checking The Original Data Image [Preview]; Operation Procedure In The [Preview] Screen - Riso MH Series User Manual

Checking the Original Data Image
[Preview]
You can check the scan image of the original and
the original data image that is retrieved from [Stor-
age] or [USB Job List].
BYou cannot use this function with the fol-
lowing functions.
C[Ink Saving] (A
C[Quick Master Making]
C[Output reversal]
BIn dual-color mode, [Preview] is turned
[ON] automatically. However, when [Quick
Master Making] (A
[ON], [Preview] is turned [OFF].
B[Preview] is turned [ON] automatically
when the following functions are set: How-
ever, if [Auto Preview]
is [OFF], [Preview] is set to [OFF].
(A 73)
C[Layout]
C[Multi-Up Print]
C[2 Up] (A 80)
■ Description of the screen
1
2
3
4
5
6
1 Touch this button to enlarge the view by one level.
2 Touch this button to reduce the view by one level.
3 Touch this button to switch between [R (vertical)] and
[Q (horizontal)] alternately.
4 Shows the current magnification rate.
5 Touch this button to change the magnification rate so
that the whole view of the original data image fits in the
display area.
6 Use these buttons to move the display position.
7 Shows the original data image.
Touch an image to move its display position so that the
touched image is displayed in the center of the screen.
8 In the case of originals for dual-color printing, the tab
buttons below are displayed. Touch the tab buttons to
switch the display screens.
[k + l]: Image that is overprinted in dual-color.
[k]: Image to be printed with print drum (cylinder) 1.
[l]: Image to be printed with print drum (cylinder) 2.
58)
(A 59)
(A 85)
139) under [Admin.] is
(A 143) in [Admin.]
(A 75)
7 8
Chapter 3 Functions for Master Making
BEven when the image is fully displayed
in the [Preview] screen, the image parts
outside the range for master making are
not printed. Check that the margins are
sufficient.
(A 18 "Master making area")
■ How to display the preview
You can display the [Preview] screen in the following
situations.
Situation Display method
Making a master Touch [Preview] in the [Functions] tab
for a paper origi- screen of the master making basic
nal screen. After scanning of an original,
the [Preview] screen is displayed.
Saving a paper Touch [Preview] in the [Functions] tab
original as data screen of the scan basic screen. After
scanning an original, the [Preview]
screen is displayed.
Printing original Touch [Preview] in the [Basic] tab
data received screen of the master making basic
from the com- screen for the original data.
puter
B[Preview] is not avail-
able when [Auto Pro-
cess] is turned on as the
operation does not stop
before master making.
Printing the There are the following two methods.
saved original • Touch [Preview] in the [Storage
data Retrieve] or [USB Job List] screen.
• Touch [Preview] in the [Basic] tab
screen of the master making basic
screen for the original data.
Operation procedure in the [Preview]
screen
This section describes the operation procedure to
make a master from a paper original as an example.
1
Touch [Preview] in the [Functions]
tab screen.
2
Set the master making conditions.
(A 52 "Functions for Master Making")
(A 108 "Useful Functions")
3
Press the [START] key.
Scanning of the original starts.
After the original has been scanned, the [Pre-
view] screen is displayed.
83
3