Riso MH Series User Manual page 202

200
Chapter 11 Troubleshooting
Problem
(Continued from the previ-
ous page)
The printed paper is peeling,
or the leading edge becomes
wrinkled.
Point to check
Check if the paper stripper
pressure is adjusted prop-
erly.
Check if [Paper Feed Adj.] is
set properly.
Check if the angle of the
stripper plate is appropriate.
Action
Turn the adjustment dial for the stripper pressure to
adjust the stripper pressure in accordance with the
paper conditions.
BBefore the adjustment, be sure to
remove any papers from the paper feed
tray, and then confirm that the paper
feed tray has lowered to the bottom.
■ When papers that tend to produce paper dust
are used
When papers are skipped
When the back side of postcards is peeling
Turn the dial counterclockwise.
■ When multiple papers are fed
Turn the dial clockwise.
Set [Paper Feed Adj.] (A
appropriate adjustment values, consult your dealer
or authorized service representative.
Turn the adjustment dial
plate angle to adjust the angle of the stripper plate.
102) as necessary. For
(A 199) for the stripper