Riso MH Series User Manual page 67

BDo not create dots that cause
high contrast.
BThe maximum number of pen
frames that you can use for one
original is 20. Drawing more than
20 frames results in an error.
BKeep at least 3 mm (1/8 inches)
between pen frames. If frames are
too close to each other or over-
lap, the frames are not recog-
nized as pen frames.
Correct
3 mm (1/8 inches)
BKeep a pen frame approximately
3 mm (1/8 inches) away from any
letter or image on the original.
The area within approximately 3
mm (1/8 inches) from the frame
will be missing.
BDo not double a pen frame. The
inside frame is not recognized as
a pen frame.
Wrong
BThe specified area of a pen frame
that extends outside the master
making range
rated.
2
Display the master making basic
screen for dual-color mode.
In the [HOME] screen
Color].
3
Place an original.
(A 33 "Placement of Originals")
Wrong
Wrong
3 mm (1/8 inches)
(A 18) is not sepa-
(A 24), touch [m Dual-
Chapter 3 Functions for Master Making
BPlace the original on the glass
platen. The optional auto docu-
ment feeder cannot be used.
4
Place the paper.
(A 30 "Setting up the paper feed tray and the
paper")
5
Set the paper receiving tray.
(A 31 "Setting up the paper receiving tray")
6
Touch [Separation] in the [Func-
tions] tab screen.
7
Touch [Specified area].
BThe lower right part of the screen
displays the print drum (cylinder) to
which the original is assigned: [k
(Print Drum 1)] or [l (Print Drum
2)]. Touch [Sw.Color] to switch the
print drums (cylinders).
8
Touch [OK].
9
Set the other required printing
conditions.
(A 52 "Functions for Master Making")
10
Press the [START] key.
Scanning of the original starts.
65
3