Riso MH Series User Manual page 200

198
Chapter 11 Troubleshooting
Problem
The printed papers that have
been output are not neatly
piled up in the paper receiv-
ing tray.
Printed papers go over the
paper stopper of the paper
receiving tray.
Point to check
Check if the positions of the
receiving-tray paper guides
and paper stopper are
appropriate.
Check if the position of the
paper-feed setting lever is
appropriate.
-
Action
Fit the receiving-tray paper guides and the paper
stopper to the paper size.
For thick papers, slightly widen them.
(A 31 "Setting up the paper receiving tray")
Select the position of the paper-feed setting lever
according to the paper type.
(A 30 "Setting up the paper feed tray and the
paper")
Level the paper receiving tray using the following
steps.
1 Fold the receiving-tray paper guides and the
paper stopper.
2 Lift up the sides of the paper receiving tray with
both hands, and then move the paper receiving tray
shaft to position B of the bearing.
B: When papers go over the stopper
A: Normal position