Table of Contents
Advertisement
96
Chapter 4 Functions for Printing
Functions for Printing
For the details and setting procedure of each func-
tion, see the pages that are specified as a refer-
ence.
■ Functions that are set using hardware
keys
[SPEED]
(A
96)
You can adjust the print speed.
[DENSITY]
(A
97)
You can adjust the print density.
[PRINT POSITION]
You can adjust the print position.
■ Functions that are set using the touch
panel
[Paper Size]
(A
72)
You can select a custom paper size.
[Interval]
(A
99)
You can reduce offsetting of ink on printed paper.
[Renew Page]
(A
You can make a master again using the image that
was used for the latest master making.
[Auto Page Renewal]
Master making is automatically performed again
each time a specified number of sheets has been
printed.
[OneSide MasterMake]
During dual-color printing, you can replace the origi-
nal and remake a master for only one of the print
drums (cylinders).
[Special Paper Ctrl]
You can adjust the paper feeding and paper receiv-
ing conditions when using special paper.
[Jump Wing Control]
You can adjust the position of the paper jumping
wings to facilitate the receiving of special paper.
[D-Feed Check]
(A
You can turn on and off the function to check if over-
lapped sheets of paper are fed.
(A
98)
100)
(A
101)
(A
101)
(A
102)
(A
106)
106)
Adjusting the Print Speed
[SPEED]
You can adjust the print speed.
It is possible to adjust the print speed not only
before but also during the printing process.
BYou can change the default setting in [Print
Speed]
(A
138) under [Admin.].
1
Press the [SPEED] key ([O] or
[N]).
• Each press of the [O] key decreases the print
speed by one level.
• Each press of the [N] key increases the print
speed by one level.
The table below shows the relation between
the print speed lamp status and the print speed.
Lamp
Print speed (sheets /
minute)
Approximately 60
Approximately 80
Approximately 100
Approximately 110
Approximately 120
Approximately 150
([High Speed]
)
*
Advertisement
Table of Contents
Troubleshooting
