[Specified Area] - Riso MH Series User Manual

64
Chapter 3 Functions for Master Making
■ [Green/Red]
When printing with green and red drum colors,
the original is separated at optimum conditions.
Original
10
Touch [OK].
11
Set the other required printing
conditions.
(A 52 "Functions for Master Making")
12
Press the [START] key.
Scanning of the original starts.
13
Check if separation is performed
as intended.
The [Preview] screen
scanning the original.
• Touch [Continue] to start master making.
• Touch [Editor] to move to the [Editor] editing
screen. You can use the touch panel to
change the areas that you want to separate.
Separation result
(A 83) is displayed after

[Specified area]

Select this option for originals that contain photos.
Using a commercially available red marker pen, draw
frames (pen frames) directly on the areas that you
want to separate on the original.
A range of 1 mm to 3 mm (3/64 inch to 1/8 inch) is
available for the pen width.
Print drum (cylinder) 1
(Outside the areas)
Original
The original is separated into inside and outside of the
specified area.
BWhen using [Specified area], you can-
not select [Auto] under [Contrast].
1
Draw pen frames to enclose the
areas that you want to separate on
the original.
BEnsure that the ends of the pen
frame are connected. If the ends
are not connected, the line is not
recognized as a pen frame.
Correct
BKeep the line width of the pen
frame between 1 mm and 3 mm
(3/64 inches and 1/8 inches). If the
line width is less than 1 mm (3/64
inches) or greater than 3 mm (1/8
inches), the line is not recognized
as a pen frame.
BIf a frame is smaller than a 10 mm
× 10 mm (13/32 inches × 13/32
inches) square, the frame is not
recognized as a pen frame.
Print drum (cylinder) 2
(Inside the areas)
Print result
Wrong
1 mm (3/64 inches)
(2.8 pt)
3 mm (1/8 inches)
(8.5 pt)