Riso MH Series User Manual page 185

Code Message
C16 Expired
Ink 2 & Master
Replace them
C17 Expired
Ink 1, Ink 2 & Master
Replace them
■ D00-0000: Installation error
Code Message
D02 Wrong-Type
Print Drum Installed
in Drum Position 1
Replace with
Correct Type
D04 Wrong-type
Ink Cartridge Installed
in Print Drum 1 or
Cannot Read Ink Info
Replace Ink Cartridge
or Contact Dealer
/Riso Office
D17 Wrong-type Master
Installed
or Cannot Read
Master Info
Replace Master Roll
or Contact dealer/Riso
Office
D42 Wrong-Type
Print Drum Installed
in Drum Position 2
Replace with
Correct Type
Action
Replace the ink cartridge and the master roll with new ones.
(A 168 "Replacing the Ink Cartridge")
(A 165 "Setting the Master Roll")
Replace the ink cartridges and the master roll with new ones.
(A 168 "Replacing the Ink Cartridge")
(A 165 "Setting the Master Roll")
Action
Set an appropriate print drum (cylinder) in place.
(A 171 "Replacing the Print Drum (Cylinder)")
BUse the dedicated print drum (cylinder) for this machine.
If other print drums (cylinders) are used, it may result in
malfunctions or problems.
Check that the type and color of the ink cartridge are appropriate.
Set an appropriate ink cartridge in place.
BUse the ink cartridge that is recommended by RISO. If
other ink cartridges are used, it may result in malfunc-
tions or problems.
Check if the label at the edge of the ink cartridge has been peeled off or
stained.
The label at the edge of the ink cartridge contains the necessary infor-
mation for printing. Set an ink cartridge in place on which an unstained
label is properly attached.
(A 168 "Replacing the Ink Cartridge")
Check that the type of master roll is appropriate.
Set an appropriate master roll in place.
BUse the master roll that is recommended by RISO. If other
master rolls are used, it may result in malfunctions or
problems.
Check if the [ I ] section of the master core is bent or cut.
The [ I ] section of the master core contains the necessary information
for printing.
Set a master roll in place that contains a [ I ] section that is not bent or
cut.
(A 165 "Setting the Master Roll")
Set an appropriate print drum (cylinder) in place.
(A 171 "Replacing the Print Drum (Cylinder)")
BUse the dedicated print drum (cylinder) for this machine.
If other print drums (cylinders) are used, it may result in
malfunctions or problems.
Chapter 11 Troubleshooting
183
11