Adjusting The Position Of Paper Jumping Wings [Jump Wing Control]; Monitoring The Feeding State [D-Feed Check] - Riso MH Series User Manual

106
Chapter 4 Functions for Printing
Adjusting the Position of Paper
Jumping Wings
[Jump Wing Control]
The paper jumping wings are used to eject the
printed paper to the paper receiving tray. Normally,
the position of the paper jumping wings is adjusted
automatically according to the paper size and selec-
tion of the position of the paper-feed setting lever
(A 30).
When you use paper for which the position cannot
be adjusted automatically, turn on [Jump Wing Con-
trol]. The paper jumping wings are moved to a spe-
cial position.
BIf [Jump Wing Control] is not displayed,
special settings are required. For more
information, consult your dealer or
authorized service representative.
BYou can change the default setting in
[Jump Wing Control]
[Admin.].
1
Touch [Jump Wing Control] in the
[Functions] tab screen.
Paper jumping wings
(A 139) under
Monitoring the Feeding State
[D-Feed Check]
This machine is equipped with the [D-Feed Check]
function, which automatically stops printing when
the feeding of overlapped sheets of paper (double
feeding) is detected.
[D-Feed Check] is on as a factory default setting.
However, since this function is set for normal paper
types, the function may detect some paper statuses
as an error even when double feeding does not
occur.
To avoid such faulty detection, turn OFF [D-Feed
Check] in the following cases:
• A [D-Feed Check] error is repeatedly displayed
when no double feeding occurs.
• Paper with a dark ground color is used (such as
black, red, or deep blue).
• The back side of the paper is already printed.
BYou can change the default setting in
[Double Feed Check]
[Admin.].
1
Touch [D-Feed Check] in the
[Functions] tab screen.
(A 139) under