Sending E-Mail - Riso MH Series User Manual

■ [Subject]
Enter a subject for the e-mail as necessary.
■ [Message (Add Comment)]
Enter the body of the e-mail as necessary.
■ [Signature]
Enter a signature to be contained in the body of
the e-mail as necessary.
■ [Send Transmission Result to
Administrator]
When you select [Send], the result of e-mail
transmission (success or failure) is sent to the
address specified in [Administrator Address].
■ [Administrator Address]
If you select the [Send] option for [Send Trans-
mission Result to Administrator], enter the des-
tination address for the result of e-mail
transmission.
■ [Subject]
Enter a subject for the e-mail that indicates the
result of e-mail transmission as necessary.
■ [Signature]
Enter a signature to be contained in the body of
the e-mail that indicates the result of e-mail
transmission as necessary.
8
Click [OK] located at the bottom of
the screen.
The settings that you changed are applied.
9
Check that the [E-mail] button is
available in the [ID Counter
Report] screen of this machine.
BOnce you have performed the set-
tings on the RISO Console, you can
change the settings in [Copy Count
Mail] (A 142) under [Admin.] as
well.

Sending e-mail

BPerform the procedure of "Presetting"
(A 124) in advance.
1
Touch [E-mail] in the [ID Counter
Report] screen.
The e-mail is sent to the preset e-mail
addresses.
After the e-mail has been sent, the basic
screen is displayed.
125
Chapter 5 Useful Functions
5