Checking The Print Image Prior To Making Master [Preview] - Riso MZ770 User Manual

Checking the Print Image Prior to Making
Master
[Preview]
You can check what the actual master will look like by previewing an image of the scanned original or an image of
data sent from a computer. This function is handy for making sure that the "Easy 2Colour" separation was successful,
and for checking the layout or final image of a Multi-Up job.
The operation and display timing differ depending upon the mode.
Mode name
(original type)
Printing from the Original
Document
Scan Mode
Printing Original Data
from a Computer
Retrieving Stored Data
and Printing
Note:
• Preview shows an image oriented towards output after printing.
• It shows the scanned original as-is. A margin is required when actually printing. Check to make sure that the mar-
gins are sufficient.
• If you are 2-Colour printing, a 2-Colour preview will be displayed after the original has been scanned on Drum 1
and Drum 2.
• Even if a single original has been separated using the "Easy 2Colour" function, each of the separated results is dis-
played.
• In "Direct Print" operation, [Preview] will be displayed on the Master Making Basic Screen when data is received
from the computer.
p.66
• When in Link mode (when a linked printer (sold separately) is connected), the original image after scanning and
prior to output from the linked printer is previewed.
RISO EUROPE LIMITED & European Subsidiaries
When set
When setting functions
related to Master Making
(settings from Functions)
When setting functions
(master making functions)
related to Scanning (setting
from Functions)
Stopping the print job prior to
making a master (Semi-
Auto(Print)/Auto Process
OFF), after the machine has
received the original data
When retrieving stored data
(set on the Storage Basic
Screen)

Checking the Print Image Prior to Making Master [Preview]

When to display
After Scanning the
Original
After Scanning the
Original
Displays when touched
Displays when touched
Functions for Master-Making
If "Auto Processing" is ON
Scans the original, then
temporarily stops to display
preview.
When in scan mode, an
original is scanned and then
saved, so there is no "Auto
Process" operation.
However, if multiple originals
are placed in an ADF unit,
you can touch [Continue]
after reviewing the preview
to start the scan of the next
original.
A preview is not shown if
data is sent from the printer
driver with "Auto Print" "ON".
If you touch [Preview], it
displays immediately.
Touch [Continue] to make a
master/print with "Auto
Process".
107