Viewing Abnormal System Conditions With The Display Time Key; Clearing The Alarm Verification Tally; Viewing Power Supply/Charger Voltage And Current Readings - Simplex 4100 Operating Instructions Manual

8. When finished, press the <CLR> key on the ENTRY keypad to escape from the Main Menu.

VIEWING ABNORMAL SYSTEM CONDITIONS WITH THE DISPLAY TIME KEY

NOTE: The system must have an abnormal condition showing on the alphanumeric display before the Display Time
Key can be used.
To view Abnormal System Conditions with the <DISPLAY TIME> key, perform the following procedure.
1. Press the appropriate acknowledge (ACK) key on the operator interface panel to view the desired condition.
2. Press and hold the <DISPLAY TIME> key on the DISPLAY/ACTION keypad to display the time and date
tag for the first event.
NOTE: If the log was cleared while the event condition existed, the time and date tag will not be found.
3. Alternately press the appropriate acknowledge key and <DISPLAY TIME> key to scroll through events and
display their time and date tags.

CLEARING THE ALARM VERIFICATION TALLY

To clear an Alarm Verification Tally, perform the following procedure.
NOTE: The following procedure is for a MAPNET II
the <ZN 1> key and enter the zone number. Press the <ENTER> key. Then go to Step 4 and continue the
procedure.
1. Press the <MAP 6> key on the ENTRY keypad.
• The display now prompts you for the MAPNET II
2. Using the ENTRY keypad, press the appropriate numeric key for the device's channel (1 through 9, or 0),
the hyphen <-> key, and the appropriate numeric key(s) for the device number (1 through 127). Then press
the <ENTER> key.
3. To verify the MAPNET II
4. To display the Alarm Verification Tally, simultaneously press the <FUNCTION> key and the <NEXT> or
<PREVIOUS> key until the display shows "F1=Clear Verification Tally."
5. Press the <F1> key to clear the Alarm Verification Tally. If your Access Level is insufficient for this operation,
a statement to that effect will appear on the display, and no action will occur.
6. To exit from this operation, press the <CLR> key on the ENTRY keypad until the original display re-appears.
NOTE: Use P214 to clear all verification tallies.

VIEWING POWER SUPPLY/CHARGER VOLTAGE AND CURRENT READINGS

To view power supply voltage and current readings, perform the following procedure.
1. Press the <MENU> key on the DISPLAY/ACTION keypad. Then press the <NEXT> key six times.

device. To clear an Alarm Verification Tally on a ZONE, press


device number, press the <FUNCTION> key on the DISPLAY/ACTION keypad.
86
firealarmresources.com
channel and device number.