Appendix Abbreviated Operator Interface Procedures; Operator Log In/Log Out Procedures; Access Level Log In Procedure - Simplex 4100 Operating Instructions Manual

ABBREVIATED OPERATOR INTERFACE PROCEDURES

OPERATOR LOG IN/LOG OUT PROCEDURES

ACCESS LEVEL LOG IN PROCEDURE

NOTE: Various functions may be passcode protected to prevent access by unauthorized personnel. Passcodes
are provided to the user during system installation. To change or receive additional information concerning
your passcodes, contact your local Simplex Branch Office.
To Log In, perform the following procedure.
1. Obtain the appropriate passcode information.
2. Open the interface panel access door.
3. Press the <MENU> key on the DISPLAY/ACTION keypad on the right side of the interface panel. The
following is displayed.
Press <NEXT> or <PREVIOUS> to scroll
Change Access Level?
4. Press the <ENTER> key on the DISPLAY/ACTION keypad. The following is displayed.
F1=Login
CURRENT ACCESS LEVEL = 1
5. Press the <F1> key (above the alphanumeric display). The display shows the following.
Enter a Passcode followed by <ENTER>
6. Enter the passcode (up to 10 numbers). Press the <ENTER> key on the ENTRY keypad. For security
reasons, an "X" is displayed for each digit of your passcode, as shown below.
Enter a Passcode followed by <ENTER>
XXX
If the passcode is correct, the following is shown.
Enter a Passcode followed by <ENTER>
ACCESS GRANTED
APPENDIX
F2=Logout
81
firealarmresources.com