Simplex 4100 Operating Instructions Manual page 70

The zone number for the selected prefix can now be entered. The input must be terminated with an <ENTER> key
press. If the identifier represents a valid point in the system, the point is displayed as shown in the example below
(20 was entered for this example).
Please input a ZONE number
MONITOR ZONE: ZN20
If the keypad input is invalid, the incorrect keypad entry is held in the display on the bottom line along with the error
message on the top line as shown below.
ERROR...INVALID IDENTIFIER
MONITOR ZONE: ZNXX
NOTE: XX equals the invalid identifier.
This data is briefly displayed. Then, the user is prompted to enter a ZONE or ADDRESS prefix as shown below:
Please enter a ZONE or ADDRESS prefix
A complete listing of system points is located within the Programmer's Report. Each system point has an associated
Custom Label which identifies a specific location within the building. Pseudo points have Custom Labels which
identify their purpose.
Shown below is an example of a Programmer's Report entry describing a MAPNET II
M1-2
The "M1" identifies the MAPNET II
FLOOR EAST WING, ROOM 13." When entering MAPNET II
the channel from the device.
To display the status of the above MAPNET II
1. Press the <MAP> key (key 6). The alphanumeric display prompts the operator for a MAPNET II
Address input as shown below.
Please input Channel-Device (C-DDD)
MAPNET POINT: M
NOTE: The display shows (C-DDD). "C" is the MAPNET II
number (1 to 127).
2. Use the Numeric keypad to enter the MAPNET II
key. The alphanumeric display shows the MAPNET II
3RD FLOOR EAST WING
FIRE MONITOR ZONE
3RD FLOOR EAST WING

card or Channel; the "-2" identifies the device.

point, perform the following.
firealarmresources.com
ROOM 13

Zone Names, a hyphen must be used to separate

channel (1 to 9, and 0); "DDD" is the device

Point Address, such as M1-2, then press the <ENTER>

point status and its custom label as shown below.
ROOM 13
62

point.
ALARM MBZAM
The custom label is "3RD

NORMAL
Point