Nfpa Standards - Johnson Controls FC-2000 Installing

In addition, the following equipment is required for the specific NFPA
standards listed below:
An NFPA-72 Remote Station Protected Premises Control Unit requires:
6. Sprinkler Supervisory service requires a CRM-4 Control Relay
An NFPA-72 Proprietary Protected Premises Control Unit requires:
6. NIB-96 Network Interface Board. Refer to the Applications section of
An NFPA-71 Central Station Protected Premises Control Unit requires:
6. 911A Digital Alarm Communicator. Refer to the Applications section
7. Sprinkler Supervisory and/or Waterflow Alarm service requires a
An NFPA-72 Emergency Voice/Alarm Communication System requires:
6. VTCC-1, VCC-2 or VTCC-2 Voice/Telephone Command Center for
7. AA-120 Audio Amplifier
8
Before proceeding, the installer should be familiar with the following
NFPA
standards (as appropriate):
Standards
All manuals and user guides at all-guides.com
Module and a cable assembly (Part No. 71270). Refer to the
Applications section of this document.
this document. Not for sprinkler supervisory service.
of this document.
CRM-4 Control Relay Module. Refer to the Applications section of
this document.
a voice evacuation system
VCM-4 Voice Control Module for up to four speaker or telephone
circuits or DCM-4 Dual Channel Module
NFPA 71 Installation, Maintenance, and Use of Central Station
Signaling Systems
NFPA 72 Installation, Maintenance, and Use of Local, Auxiliary,
Remote Station, and Proprietary Protective Signaling Systems
NFPA 72 Emergency Voice Alarm Service
NFPA 72 Automatic Fire Detectors
NFPA 72 Installation, Maintenance, and Use of Indicating Appliances
for Protective Signaling Systems
NFPA 72 Testing Procedures for Signaling Systems
Installation—Installing the FC-2000 5