Table of Contents
Advertisement
APPX. 3 INSTALLATION CHECK LIST
After completing the installation, perform the following checks:
Hardware installation check
O-ring in the retraction tank
flange
O-ring in the attachment flange
(when the attachment flange is
used)
Insulated gasket in the bolt
holes on the attachment flange
(when OP10-24 is used)
Bow mark direction of the
transducer
Breaker settings on the power
supply unit
Vibration and sound while
raising/lowering the transducer
Software setting check
Language setting
Transducer position
registration
Turn the transmission on
Heading Correction
Direction offset of the motion
sensor
Stroke setting
External data setting
System time setting
Save ship's original setting
Display setting for the
numeric/graphic data display
Continued of following page
Check point
O-ring is attached to the retraction
tank flange.
O-ring is attached to the attachment
flange.
Insulated gaskets are inserted to
the bolt holes on the attachment
flange.
Confirm that the bow mark on the
transducer faces the bow direction.
Breaker lever on the power supply
unit are changed correctly, depend-
ing on the input voltage.
Confirm that abnormal vibration or
noise is not generated from the hull
unit while raising/lowering the trans-
ducer.
The language in which the menus
and indications is changed as nec-
essary.
The transducer position registration
is completed.
Change the transmission status
from [OFF] to [ON].
Adjust the heading so an echo
which is dead ahead appears dead
ahead on the display.
Offset the direction difference be-
tween the [Reference Direction]
mark on the motion sensor and bow
direction.
Select 1200 mm or 1600 mm ac-
cording to the stroke (length) of your
hull unit.
Set the baud rate for the
NMEA2000 port and select the input
format for external data.
Set the system time and time zone.
Save all menu settings in the inter-
nal memory as necessary.
Change the display setting for the
numeric/graphic data display as ap-
propriate.
Reference
Result
section 1.1.3
section 1.9
section 1.9
section 1.1.3
section 2.7
-
section 3.1
section 3.2
section 3.3
section 3.4
section 3.4
section 3.8.4
section 3.8.2/
section 3.8.3
Operator's
manual
Operator's
manual
Operator's
manual
AP-5
Advertisement
Table of Contents
