Table of Contents
Advertisement
1. HOW TO INSTALL THE SYSTEM
1.9.2
When tank extension is required
If you need to extend to the tank length when installing to an existing retraction tank,
use the optional attachment kit and attachment flange.
Select the correct attachment flange from the following table, using the length of the
pre-installed tank to determine the raising height.
Attachment flange
Note: Do not use multiple attachment flanges to a retraction tank.
The Items supplied with the attachment kit and attachment flange are listed in the fol-
lowing table.
Name
Attachment kit
Insulated gaskets (1) MS-1000-67-1
Insulated gaskets (2) MS-1000-68-1
Attachment flange
Attachment Flange
O-Ring
Spring Washer
Flat Washer
Hex. Nut
Hex. Head Screw
*: 24 flat washers are included with OP10-42.
Note: Remove marine life (barnacles, etc.) from the existing retraction tank before in-
stalling the hull unit.
1. Clean the flange and O-ring groove of the retraction tank (welded to hull) with ethyl
alcohol moistened waste cloths.
2. Apply lithium grease to the O-ring and O-ring groove. Place the O-ring in its
groove on the tank flange.
3. Confirm the following points as below and place the attachment flange on the
retraction tank.
• Clean the flange platform.
• Wipe the undersurface of the attachment flange with clean waste cloths.
• Keep O-ring in its position.
1-20
Name
Flange type
OP10-42
OP10-38
OP10-39
OP10-43
OP10-44
Type
10-089-5701-2
10-089-5702-2
10-089-5703-2
10-089-5704-2
10-089-5705-2
C0 0318A (V585)
M20 SUS304
M20 SUS304
M20 SUS304
M20X120 SUS304
Raising height
150 mm
200 mm
250 mm
280 mm
315 mm
Code No.
Qty
100-347-601-10
24
100-347-611-10
24
100-387-342-10
100-387-352-10
100-387-362-10
1
100-387-372-10
100-387-382-10
000-166-370-10
1
000-167-401-10
24
000-167-452-10
48*
000-167-476-10
48
000-162-476-10
48
Remarks
For OP10-42
For OP10-38
For OP10-39
For OP10-43
For OP10-44
Not included for
OP10-42.
Advertisement
Table of Contents
