5. Unfasten four screws and set the inertial measurement unit, then fasten the
screws to secure it.
6. Connect the D-SUB connector inside the control box extension box to the inertial
measurement unit.
7. Fasten the ground wire (crimp-on lug) of the D-SUB cable to the ground terminal.
8. Reattach the top cover and front cover.
Inertial measurement unit
Connect the D-SUB
cable to the inertial
measurement unit.
Fasten the ground wire
of the D-SUB cable to
this location.
Rear side: Inertial measurement unit
Set the unit to the mounting screws,
then fasten the screws.
2. WIRING
2-21