Furuno FSV-25 MARK-2 Installation Manual page 17

5. Fasten the four wing nuts (supplied) to the stud bolts from the rear side of the
mounting surface.
Wing nut
(4 pcs)
1.3.2 Tabletop mounting with KB fixture
The control unit can be mounted with the KB fixture, which mounts the unit at an angle.
1. Drill four pilot holes in the mounting location for mounting screws, referring to the
outline drawing at the back of this manual.
2. Secure the KB fixture (supplied) to the mounting location, using four self-tapping
screws (520, supplied).
Note: Secure the KB fixture so that the cutout is located on the side farthest from
the operator.
Cutout should be located on
the side farthest from the
operator.
1. HOW TO INSTALL THE SYSTEM
Self-tapping screw
(Ø5×20, 4 pcs)
KB fixture
1-9