Language In The Display; Language Change - AUMA SQEx 05.2 Operating Instructions Manual

SQEx 05.2 SQEx 14.2/SQREx 05.2
ACExC 01.2 Non-Intrusive Profibus DP
7.5.

Language in the display

7.5.1.

Language change

Select main menu
Change language
Language selection
SQREx 14.2 Control unit: electronic (MWG)
timeout is displayed on the screen. An individual timeout is available for each user
level. This means that you may still log on with user level 3 if user level 4 is inhibited.
The incorrect entry counter can be reset in two ways:
1. Correct password entry with successful access authorisation.
2. 8 hours after the last incorrect entry.
The display language can be selected.
Display M0009
Language M0049
1. Set selector switch to position 0 (OFF).
2. Press push button C Setup and hold it down for approx. 3 seconds.
Display goes to main menu and indicates: ▶ Display
3. Press Ok.
Display indicates: ▶ Language
4. Press Ok.
Display indicates the selected language, e.g.: ▶ Deutsch
5. The bottom row of the display indicates:
Save → continue with step 10
Edit → continue with step 6
6. Press Edit.
Display indicates: ▶ Observer (1)
7. Select user level via
black triangle: ▶ = current setting
white triangle: ▷ = selection (not saved yet)
8. Press Ok.
Display indicates: Password 0***
9. Enter password (→ enter password).
Display indicates: ▶ Language and Save (bottom row)
10. Select new language via
black triangle: ▶ = current setting
white triangle: ▷ = selection (not saved yet)
11. Confirm selection via
The display changes to the new language.The new language selection is saved.
Up ▲ Down ▼ resulting in the following significations:
Up ▲ Down ▼ resulting in the following significations:
Save.
Operation
51