AUMA SQEx 05.2 Operating Instructions Manual page 77

SQEx 05.2 SQEx 14.2/SQREx 05.2
ACExC 01.2 Non-Intrusive Profibus DP
SQREx 14.2 Control unit: electronic (MWG)
2. Refer to table and check if swing angle of the actuator corresponds to the setting
of the reduction gearing (stages 1 9).
If the setting is not correct: continue with step 4.
If the setting is correct: continue with step 7.
Table 28:
Actuator swing angle and suitable reduction gearing setting
SQ 05.2 / SQ 07.2
30° +/ 15° 2
60° +/ 15° 3
90° +/ 15° 3
120° +/ 15° 3
150° +/ 15° 4
180° +/ 15° 4
210° +/ 15° 4
290° +/ 70° 5
3. Loosen screw [1].
4. Set crown wheel [2] to desired stage according to table.
5. Tighten screw [1].
6. Place indicator disc on shaft.
7. Set mechanical position indicator.
Figure 87: Control unit with reduction gearing
[1] Screw
[2] Crown wheel
Commissioning (settings in the actuator)
SQ 10.2 SQ 12.2
2 3
3 4
3 4
4 5
4 5
4 5
5 6
5 6
SQ 14.2
4
5
6
6
6
7
7
7
77