Mechanical Position Indication Via Indicator Mark (Not Self-Adjusting) - AUMA SQEx 05.2 Operating Instructions Manual

SQEx 05.2 SQEx 14.2/SQREx 05.2
ACExC 01.2 Non-Intrusive Profibus DP
11.3.

Mechanical position indication via indicator mark (not self-adjusting)

Setting elements
SQREx 14.2 Control unit: electronic (MWG)
1. Refer to table and check if swing angle corresponds to the setting of the reduc-
tion gearing (stages 1 9).
Table 27:
Actuator swing angle and suitable reduction gearing setting
SQ 05.2 / SQ 07.2
30° +/ 15° 2
60° +/ 15° 3
90° +/ 15° 3
120° +/ 15° 3
150° +/ 15° 4
180° +/ 15° 4
210° +/ 15° 4
290° +/ 70° 5
2. To modify settings, lift the lever at the reduction gearing and engage at the se-
lected stage.
Figure 85: Set reduction gearing
Figure 86: Mechanical position indication via indicator mark
The mechanical position indicator shows the valve position via two indicator discs
with symbols (OPEN) and
OPEN/CLOSED point to the indicator mark
The position indications is housed in the actuator switch compartment. The switch
compartment must be opened to perform any settings. Refer to <Switch compartment:
open/close>.
Commissioning (settings in the actuator)
SQ 10.2 SQ 12.2
2 3
3 4
3 4
4 5
4 5
4 5
5 6
5 6
(CLOSED). When correctly set, the symbols
at the cover in the end positions.
SQ 14.2
4
5
6
6
6
7
7
7
75