Gateway 920 User Manual page 61

To install or replace memory:
1
Follow the instructions in
page 41.
2
Open the server case by following the instructions in
case" on page 42.
3
Pull the plastic tabs away from the sides of the memory module slot. If
you are replacing a memory module, remove the old module.
4
Align the notch on the new module with the notch in the memory module
slot and press the module firmly into the slot. The tabs on the sides of
the memory slot should secure the memory module automatically.
5
Close the server case by following the instructions in
case" on page 44.
6
Turn on the server. Make sure that the server turns on and that the
operating system loads completely.
7
If your server is running Windows 2000 Server, right-click the
icon, then click
at the bottom of the Properties dialog.
- OR -
Restart and open the BIOS Setup utility. Note the
the Main menu to verify the amount of memory installed.
"Preventing static electricity discharge" on
. The amount of memory in your server is shown
Properties
www.gateway.com
Installing memory
"Opening the server
"Closing the server
My Computer
listed in
System Memory
55