Gateway 920 User Manual page 88

Chapter 6: Troubleshooting
Diskette read failed - press F1 to retry boot
■
Make sure that the startup diskette contains the command.com file.
■
Open the BIOS Setup utility, then make sure that your drive or controller
is configured correctly.
■
Press F1 to restart the server.
■
Make sure that the diskette drive cable is connected securely.
Error loading operating system
■
The master boot record may be corrupt. For troubleshooting information,
see
Hard disk controller failure
■ Make sure that the hard drive cable is connected securely.
■ Open the BIOS Setup utility, then make sure that the correct drive type is
selected.
Hard disk controller failure - press F1 to try reboot
■ The drive controller may be defective. Press F1 to try to restart the server.
Try running FDISK and DOS Format to check the integrity of the hard drive.
For more information, see your operating system's documentation.
■
See
Insert bootable media device
■
Make sure that the correct hard drive is set as the first bootable drive in
the Boot menu of the BIOS Setup utility.
■ See
server does not recognize a SCSI drive" on page 92
Insufficient disk space
■ Check the free space on the drive. If the drive is almost full, remove
unnecessary files. For more information, see
page
Invalid configuration information
■
Open the BIOS Setup utility, then make sure that the settings are correct.
■
See
82
"The master boot record is corrupted" on page
"You need to troubleshoot an IDE hard drive" on page
"Your server does not recognize an IDE drive" on page 92
24.
"Resetting the BIOS" on page 75 for a possible solution.
www.gateway.com
92.
93.
or
for a possible solution.
"Using Disk Cleanup" on
"Your